PNY MBM630I7150 Manual De Usuario

- 2 -

 nVIDIA MCP73 Series                                                                                     Users Manual

     ・ 

         

This item selects the removable device booting priority.

     ・ 

         

This item selects the hard disks booting priority. By pressing <Enter> key, you can enter 

         

its submenu where the hard disks detected can be selected for the booting sequence to 

         

boot up system.

     ・ 

         

Allow you to choose the VIRUS Warning feature for IDE Hard Disk boot sector protection. 

         

If this function is enabled and someone attempt to write data into this area, BIOS will 

         

show a warning message on screen and alarm beep.

     ・ 

         

Enable or Disable the L1 & L2 cache which is built in the processor.

     ・ 

         

When set to [Enabled], this item speeds up the Power On Self Test (POST) after powering 

         

on the system. The BIOS shorten or skip some check during the POST.

     ・ 

         

Select the drive to boot first, second and third in the [First Boot Device], [Second Boot 

         

         

Device], and [Third Boot Device] items respectively. The BIOS will boot the operating 

         

system according to the sequence of the drive selected. Set [Boot Other Device] to 

         

[Enabled] if you wish to boot from another device other than these three items.

     ・ 

         

During POST, BIOS will determine if the floppy disk drive installed if choose [Enable].

     ・ 

         

This item defines if the keyboard Num Lock key is active when your system is started.

     ・ 

         [

Normal]:           The A20 signal is controlled by keyboard controller or chipset hardware. 

         [Fast]: (default)  The A20 signal is controlled by port 92 or chipset specific method.

     ・ 

         Keystrokes repeat at a rate determined by the keyboard controller. When enabled, the 

         typematic rate and typematic delay can be selected.

     ・ 

         Set the number of times a second to repeat a keystroke when you hold the key down. 

         The settings are: 6, 8, 10, 12, 15, 20, 24, and 30. 

     ・ 

         Set the delay time after the key is held down before is begins to repeat the keystroke. 

         The settings are 250, 500, 750, and 1000.

     ・ 

         This item determines when the system will prompt for password - every time the system 

         boots or only when enters the BIOS setup.

         [Setup]:   The password is required only when accessing the BIOS Setup.

         [System]: The password is required each time the computer boots up.

     ・ 

         This field is used to enable or disable the APIC (Advanced Programmable Interrupt 

         Controller). Due to compliance with PC2004 design guide, the system is able to run in 

         APIC mode. Enabling APIC mode will expand available IRQ resources for the system.

     ・ 

         This item specifies which version of MPS (Multi-Processor Specification) this mainboard 

         will use. Leave this item at its default setting.