Dialogic M7324 Manual De Usuario

There are specific switch programming requirements that apply if using a 
Dialogic

®

 PBX Integration Board with a Nortel Norstar. Pay attention to set 

these features exactly (and assigned to the right keys) so that the PBX 
Integration Board and the associated APIs can function correctly. 

 lists the menu structure used if configuring a Nortel Norstar (with 

DR5 or later revision installed). The shaded areas indicate the actual menu 
items to change if using the KSU with a Dialogic

®

 PBX Integration Board. 

For details about programming a Norstar KSU, refer to the appropriate Norstar 
manual.  

The table only shows the configuration for one trunk line (001) and one 
extension (221). If you are using more than one trunk line, configure each 
trunk line the same. If you are using more than one extension, check that all 
the extensions are configured the same with the exception of the Forward on 
busy and Forward no answer options. For these menu items, the first 
extension should be forwarded to the second extension and the second 
extension should be forwarded to the third extension, and so on. The last 
extension should be forwarded back to the first extension. 

A-Configuration  

     1. Trk/Line Data 

 

          a)  Show line: Enter Trunk # 

001 

          b)  Trunk data 

 

               Line001: Loop* 

 

               Trunk mode: Supr 

 

               Dial mode: Pulse  

Tone  

               Full AutoHold: N 

 

          c)  Line data