Fujitsu P3NK-4452-01ENZD Manual De Usuario
XG Series User's Guide
Chapter 4 Switch Functions and their Configuration
Link Aggregation
68
4.4.1
Configuring Link Aggregation
Either static or dynamic (also known as LACP) configuration can be selected for Link Aggregation.
•
Static configuration
Configures aggregation groups statically.
Configures aggregation groups statically.
•
LACP
Configures link aggregation using Link Aggregation Control Protocol (LACP). The LACP is a switch-to-switch
control protocol that enables dynamic configuration of aggregation groups and is standardized by the IEEE802.3ad.
The LACP facilitates load balancing across the individual links aggregated between the devices connected.
Either "active" or "passive" LACP mode can be selected.
Configures link aggregation using Link Aggregation Control Protocol (LACP). The LACP is a switch-to-switch
control protocol that enables dynamic configuration of aggregation groups and is standardized by the IEEE802.3ad.
The LACP facilitates load balancing across the individual links aggregated between the devices connected.
Either "active" or "passive" LACP mode can be selected.
- active
The device starts LACP negotiation. Since the active mode allows the reception of LACP control frames, it is
possible to direct the device in "active" mode.
possible to direct the device in "active" mode.
- passive
The device responds to LACP control frames but does not start LACP negotiation.
To configure static link aggregation, carry out the following procedure in "admin" Operation mode.
To configure LACP link aggregation, carry out the following procedure in "admin" Operation mode.
Command
Task
XG2600# configure
Switch to Configuration mode.
XG2600(config)# ether 1-8 type linkaggregation 1
Set port 1-8 to be linkaggregation group 1.
XG2600(config)# linkaggregation 1 mode static
Set linkaggregation group 1 to be static.
XG2600(config)# commit
Apply the configuration.
XG2600(config)# save
Save the configuration.
XG2600(config)# exit
Switch to Operation mode.
Command
Task
XG2600# configure
Switch to Configuration mode.
XG2600(config)# ether 1-8 type linkaggregation 1
Set port 1-8 to be linkaggregation group 1.
XG2600(config)# ether 11-18 type linkaggregation 2
Set port 11-18 to be linkaggregation group 2.
XG2600(config)# linkaggregation 1 mode active
Set linkaggregation group 1 to be active.
XG2600(config)# linkaggregation 2 mode passive
Set linkaggregation group 2 to be passive.
XG2600(config)# commit
Apply the configuration.
XG2600(config)# save
Save the configuration.
XG2600(config)# exit
Switch to Operation mode.