Fujitsu P3NK-4452-01ENZD Manual De Usuario
XG Series User's Guide
Chapter 4 Switch Functions and their Configuration
Spanning Tree Protocol (STP)
73
4.5.3
Configuring Spanning Tree
To configure the spanning tree protocol, carry out the following procedure in "admin" Operation mode.
Command
Task
XG2600# configure
Switch to Configuration mode.
XG2600(config)# stp mode stp
Enable Spanning Tree Protocol.
XG2600(config)# stp domain 0 priority (0-61440)
XG2600(config)# stp hello (1s-10s)
XG2600(config)# stp age (6s-40s)
XG2600(config)# stp delay (4s-30s)
XG2600(config)# stp hello (1s-10s)
XG2600(config)# stp age (6s-40s)
XG2600(config)# stp delay (4s-30s)
Configure Spanning Tree Protocol parameters on the device.
• Switch priority
• Hello time
• Maximum aging time (max-age)
• Forward delay time (forward-time)
• Hello time
• Maximum aging time (max-age)
• Forward delay time (forward-time)
XG2600(config)# ether 1-8 stp use on
Enable Spanning Tree Protocol on port 1-8.
XG2600(config)# ether 9-20 stp use off
Disable Spanning Tree Protocol on port 9-20.
XG2600(config)# ether 1-8 stp domain 0 priority (0-240)
XG2600(config)# ether 1-8 stp domain 0 cost
(1-200000000)
XG2600(config)# ether 1-8 stp domain 0 cost
(1-200000000)
Configure the following parameters related to the spanning tree
topology:
topology:
• Port priority
• Path cost
• Path cost
XG2600(config)# commit
Apply the configuration.
XG2600(config)# save
Save the configuration.
XG2600(config)# exit
Switch to Operation mode.