Fujitsu C122-E177-01EN Manual De Usuario
MMB Web-UI (Web User Interface) Operations
Items
Description
Default value is 0 seconds.
(attention)
Other start processing is not executed until the processing of system Power On
Delay ends.
Altitude
Sets the altitude where PRIMEQEST 2800B model is installed or placed.
·
Altitude < 1000 m
·
1000 m <= Altitude < 1500 m
·
1500 m <= Altitude < 2000 m
·
2000 m <= Altitude
Default value is Altitude < 1000 m.
Setting error of altitude condition is possible up to ±100m.
PSU Redundant Mode Sets whether PSU is redundantly operated.
·
Redundant
·
Non-redundant
When Power Feed Mode is Single, it is by default Non-Redundant.
When Power Feed Mode is Dual, it is always Redundant.
System Power Save
Control
Control
Sets enable/disable for Power Saving function for entire system.
·
Enable
·
Disable
Power Saving function supports only PSU_P 200V.
Default is Disable.
System Power Saving
Threshold
Threshold
Sets the power consumption threshold (Limit value) of entire system.
Minimum value is 300W.
Maximum value is as shown below.
Minimum value is 300W.
Maximum value is as shown below.
·
PRIMEQUEST 2400E : 8640W
·
PRIMEQUEST 2800E/B : 8640W
Setting is possible only when System Power Save Control is Enable, gray-out at
the time of disable.
Default value is the maximum value of each model.
TABLE 1.140 [System Setup] window button
Buttons
Description
Apply
When items such as [Power Feed Mode] and [Power Restore Policy] are specified and [Apply]
button is clicked, the information is set.
button is clicked, the information is set.
Cancel
When [Cancel] button is clicked, returns to the original status without setting the changed or
input items.
input items.
(1) Menu Operation
[System] – [System Setup]
(2) Window Operations
Specify the items such as [Power Feed Mode] and [Power Restoration Policy] and click on the [Apply]
button.
Respective information is set.
button.
Respective information is set.
[Message]
This section describes the messages to be displayed on this window.
Message Number
Message