Gateway ALR 9200 Manual De Usuario

•

Are all jumper and switch settings on expansion cards and 
peripheral devices correct? To check these settings, refer to the 
manufacturer’s documentation that comes with them. If applicable, 
ensure that there are no conflicts—for example, two expansion 
cards sharing the same interrupt.

•

Are all DIMMs installed correctly?

•

Are all peripheral devices installed correctly?

•

If the system has a hard disk drive, is it properly formatted or 
configured?

•

Are all device drivers properly installed?

•

Are the configuration settings made with the SSU correct?

•

Is the operating system properly loaded? Refer to the operating 
system documentation.

•

Did you press the system power on/off switch on the front panel to 
turn the server on (power-on light should be lit)?

•

Are the system power cords properly connected to the system and 
plugged into a NEMA 5-15R outlet for 100-120 V

∼

 or a NEMA 6-

15R outlet for 200-240 V

∼

?

•

Is AC power available at the wall outlet?

•

If these items are correct but the problem recurs, see “Solving 
Problems” on page 159.

Problems that occur when you run new application software are usually 
related to the software. Faulty equipment is much less likely, especially if 
other software runs correctly.

Checklist

•

Does the system meet the minimum hardware requirements for the 
software? See the software documentation.

•

Is the software an authorized copy? If not, get one; unauthorized 
copies often do not work.

•

If you are running the software from a diskette, is it a good copy?

3424.boo  Page 160  Wednesday, September 2, 1998  9:23 AM