Gateway ALR 9200 Manual De Usuario

6.

Grasp the plastic carrier handle and pull it toward you to disengage the 
drive connector from the backplane connector.

7.

Carefully slide the bad drive forward out of the bay. Place the drive on 
an antistatic surface. 

8.

Position the new plastic carrier and drive assembly so that it engages 
the bay guide rails.

9.

Push the drive into the bay. To engage the latch, the carrier handle 
should be approximately at a 45

°

 angle from the vertical front of the 

chassis. As you push the drive into the bay, the two rounded notches in 
the carrier handle (Figure 22) slide onto the two round pegs inside the 
drive bay . When they engage, push the handle straight up to lock the 
notches onto the pegs and press the rounded tab on the right of the 
carrier to the left until it clears the edge of the bay and snaps into place.

10.

Close the metal door, and secure it to the chassis with the plastic latch.

11.

For security and to prevent unauthorized access to the bays, insert a 
padlock through the metal loop protruding through the door.

12.

Close the front system door.

If the SCSI drives you use have a power rating in excess of 15 watts, install 
three additional system fans: two in the front fan bay and one in the upper 
power supply bay. Purchase the additional fans through normal channels.

3424.boo  Page 57  Wednesday, September 2, 1998  9:23 AM