Advantech PCM-3350 Series Manual De Usuario
1 8
PCM-3350 User's Manual
1. Make sure that all power supplies to the system are switched off.
2. Install the SODIMM card. Install the SODIMM so that its gold pins
point down into the SODIMM socket.
3. Slip the SODIMM into the socket at a 45 degree angle and carefully
fit the bottom of the card against the connectors.
4. Gently push the SODIMM into a perpendicular position until the
clips on the ends of the SODIMM sockets snap into place.
5. Check to ensure that the SODIMM is correctly seated and all
connector contacts touch. The SODIMM should not move around in
its socket.
its socket.
Important: Only use standard form SODIMM memory modules
(as shown in the diagram below). Standardized
dimensions ensure a proper fit. Check with your
memory supplier about the SODIMM modules you will
use.
dimensions ensure a proper fit. Check with your
memory supplier about the SODIMM modules you will
use.
SO DIMM installation
2.18 SO DIMM socket (Slot1)
You can install anywhere from 8 MB to 128 MB of onboard SDRAM
memory using 8, 16, 32 or 128 MB 144-pin SODIMMs (Small Outline
Dual Inline Memory Modules).
memory using 8, 16, 32 or 128 MB 144-pin SODIMMs (Small Outline
Dual Inline Memory Modules).
2.18.1 Installing SODIMMs
Note:
The modules can only fit into a socket one way. Their
gold pins must point down into the SODIMM socket.
gold pins must point down into the SODIMM socket.
The procedure for installing SODIMMs appears below. Please follow
these steps carefully.
these steps carefully.