Aspire Digital M1610 Manual De Usuario
62
Chapter 5
Jumper Settings
This section explains how to set jumpers for correct configuration of the mainboard.
Setting Jumpers
Use the motherboard jumpers to set system configuration options. Jumpers with more than one pin are
numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.
numbered. When setting the jumpers, ensure that the jumper caps are placed on the correct pins.
System Board Jumper Setting
System Board Header Setting
Front Panel
Features
Default setting
Remark (color and
other)
On-board Jumper and
default setting (See Pin
definition for the detail)
default setting (See Pin
definition for the detail)
CLR_CMOS(PIN2_3)1
& default setting
& default setting
2-3 : Normal (Default) 1-2 : Clear CMOS
2-3 : Normal (Default)
Illustration
Pin
Signal Name
Description
1
5V_SYS
Hard disk LED pull-up(330 ohm) to 5V_SYS
2
GPIO_GRN_HDR_R Pull-up(330 ohm) to 5V_SB_SYS and connect to
SIO GPIO
3
HDD_LED_R
Hard disk active LED
4
GPIO_YLW_HDR_R
Pull-up(330 ohm) to 5V_SB_SYS and connect to
SIO GPIO
SIO GPIO
5
GND
Reset button
6
PSIN
Power Button
7
ICH_SYS_RSTJ
ICH_SYS_RSTJ
8
GND
Ground
9
5V_SYS
5V_SYS
10
KEY
Key
11
NC
Reserved. Do not use
12
5V_SB
LAN LED pull-up(330 ohm) to 5V_SB
13
NC
Reserved. Do not use
14
LAN_ACTJ
Lan active LED
Silk Screen
Footprint
Schematic Part
FP1
h2x7mzo10h85
HEADER_2X7_10