Antec NSK 4000 II Manual De Usuario

6

There may come a time when you need to reconfigure the pin-

out of a motherboard header connector.  Examples could be 

for your USB header, audio input header, or some other front 

panel connector such as the Power Button connector.

Before performing any work, please refer to your motherboard 

manual or your motherboard manufacturer’s website to be sure 

of the pin-out needed for your connector.  And we strongly 

recommend making a notated drawing before beginning work 

so that you can recover if your work is disturbed.

1.     Determine which wires you need to remove in order 

to rewire your plug to match the USB pin-outs on your 

motherboard (refer to your motherboard manual). Working 

on one connector at a time, use a very small flathead 

screwdriver or similar tool to lift up on the black tab 

located beside the gold posts (squares). This will allow 

you to easily slide out the pins from the USB plug.

2.  Working carefully so as not to damage the wires, 

connectors, or pins, slowly remove the pin from the 

connector. Repeat these steps for each wire you 

need to change.

3.  Working carefully so as not to damage the wires, connectors or pins, slowly reinsert the 

pin into the correct slot of the connector then snap closed the black tab that was lifted 

in step 1. Repeat these steps for each wire you need to change.

The NSK 4000 II / NSK 4480 II / NSK 4480B II comes with one 120mm TriCool™ fan 

pre-installed. This fan has a three-speed switch that lets you choose between quiet, 

performance, or maximum cooling. (See specifications below.) The fan is installed so that the 

air is exhausting. Connect a large 4-pin connector from the power supply to the male 4-pin 

connector on the fan.

Note: The default setting of the fan is Low. We recommend this speed for maximum 

quiet computing.

Note: The minimum voltage to start the fan is 5V. We recommend that users set the fan 

speed to High if you choose to connect the fan to a fan control device or to the Fan-Only 

connector found on some of Antec’s power supplies. A fan-control device regulates the fan 

speed by varying the voltage to it. The voltage may start as low as 4.5V to 5V. Connecting a 

TriCool™ set on Medium or Low to a fan-control device may result in the fan not being able to 

start. The already lowered voltage from the fan control device will be further reduced by the 

TriCool™ circuitry below 5V.

Size: 

                  120 x 120 x 25.4mm

Rated Voltage: 

     DC 12V 

Operating Voltage:      10.2V ~13.8V