Casio fx-CG20 Manual De Usuario

CASIO

20100801

20100801

ε

Advanced Setup provides you with total control over a number of parameters that you can 
adjust to configure the EA-200 setup that suits your particular needs.

k Advanced Setup Operations

The following procedure describes the general steps for using Advanced Setup. Refer to the 
pages as noted for more information.

1.  Display the E-Con2 main menu (page 

ε

-1).

2. Press 

1(SET). This displays the “Setup EA-200” submenu.

3. Press 

2(ADVANCE). This displays the Advanced Setup menu.

Advanced Setup Menu

4.  If you want to configure a custom probe at this point, press f(Custom Probe). Next, 

follow the steps under “To configure a custom probe setup” on page 

ε

-19.

• You can also configure a custom probe during the procedure under “To configure 

Channel Setup settings” on page 

ε

-9.

• Custom probe configurations you have stored in memory can be selected using 

Channel in step 5, below.

5.  Use the Advanced Setup keys described below to set other parameters.

• b(Channel) ...... Displays a screen that shows the sensors that are currently 

assigned to each channel (CH1, CH2, CH3, SONIC, Mic). You can 
also use this dialog to change sensor assignments. See “Channel 
Setup” on page 

ε

-9 for more information. 

• c(Sample) ....... Displays a screen for selecting the sampling mode, and for 

specifying the sampling interval, the number of samples, and the 
warm-up mode. When “Fast” is selected for “Mode”, this dialog box 
also displays a setting for turning FFT (frequency characteristics) 
graphing on and off. See “Sample Setup” on page 

ε

-11 for more 

information. 

• d(Trigger) ........ Displays a screen for configuring sampling start (trigger) 

conditions. See “Trigger Setup” on page 

ε

-13 for more information. 

• e(Graph) ......... Displays a screen for configuring graph settings. See “Graph 

Setup” on page 

ε

-17 for more information. 

• You can return the settings on the above setup screens (b through e) using the 

procedure described under “To return setup parameters to their initial defaults” below.