Casio fx-CG20 Manual De Usuario

CASIO

20100801

20100801

ε

This section describes how to use a setup configured using the E-Con2 mode to start an 
EA-200 sampling operation.

k Before getting started...

Be sure to perform the following steps before starting sampling with the EA-200.

1.  Connect the calculator to the EA-200.

2.  Turn on EA-200 power.

3.  In accordance with the setup you plan to use, connect the proper sensor to the 

appropriate EA-200 channel.

4.  Prepare the item whose data is to be sampled.

k Starting a Sampling Operation

A sampling operation can be started when any one of the following conditions exist.

• After configuring a new setup with Setup Wizard (page 

ε

-2)

• After configuring a new setup with Advanced Setup (page 

ε

-8)

• While the E-Con2 main menu (page 

ε

-1) is on the display

• While the setup memory list is on the display

The following procedures explain the first three conditions described above. See “To recall a 
setup and use it for sampling” on page 

ε

-25 for information about starting sampling from the 

setup memory list.

1.  Start the sampling operation by performing one of the function key operations described 

below.

-  If the final Setup Wizard screen (page 

ε

-4) is on the display, press b(Start Setup).

-  If the Advanced Setup menu (page 

ε

-8) is on the display, press 

1(START).

-  If the E-Con2 main menu (page 

ε

-1) is on the display, press 

4(START).

• After you perform any one of the above operations, 

a sampling start confirmation screen like the one 
shown nearby will appear on the display.