Casio FXCP400 Manual De Usuario
Chapter 15: Performing Data Communication
249
Chapter 15:
Performing Data Communication
Performing Data Communication
You can connect your ClassPad to a computer or to another ClassPad and exchange data with the connected
device. You can also connect to a CASIO Data Analyzer or a CASIO projector. This chapter explains how to
connect a ClassPad to an external device and how to transfer data between them.
device. You can also connect to a CASIO Data Analyzer or a CASIO projector. This chapter explains how to
connect a ClassPad to an external device and how to transfer data between them.
Important!
Do not press the RESTART button on the back of the ClassPad while a data communication operation is in
progress. Doing so can damage memory, resulting in loss of all memory contents and malfunction of your
ClassPad. If this happens, you will need to request repair from your CASIO Maintenance Service Provider.
Note that repair of your ClassPad will not recover any lost memory contents.
progress. Doing so can damage memory, resulting in loss of all memory contents and malfunction of your
ClassPad. If this happens, you will need to request repair from your CASIO Maintenance Service Provider.
Note that repair of your ClassPad will not recover any lost memory contents.
15-1
Data Communication Overview
This section explains how to configure communication parameters using the Communication application,
and how to use the Select Connection Mode dialog box that appears when you establish a USB connection
between your ClassPad and an external device.
and how to use the Select Connection Mode dialog box that appears when you establish a USB connection
between your ClassPad and an external device.
Using the ClassPad Communication Application
Before trying to transfer data with the ClassPad, you should perform the procedures described in this section to
configure its data communication parameters.
configure its data communication parameters.
u To configure communication parameters
1. On the application menu, tap
.
• This starts the Communication application and displays a window that
shows its current communication parameter settings.
2. Tap [Setup] and then [Open Setup Menu].
• This displays a dialog box for changing communication parameters, like
the one shown nearby.
3. Configure the communication parameter settings as described below.
• Items marked with an asterisk (*) are initial defaults.
Cable Type: To connect to another ClassPad unit or a Data Analyzer,
select “3pin cable”. To connect to a computer or a projector, select “USB
cable*”.
select “3pin cable”. To connect to a computer or a projector, select “USB
cable*”.
Speed(3Pin): Select “9600 bps”, “38400 bps” or “115200 bps*” to specify
data rate for 3-pin communication. This setting specifies the data rate when
connected to another ClassPad, or a Data Analyzer. If the speed settings of
the ClassPad and the connected device are different from each other, the
slower setting is used.
data rate for 3-pin communication. This setting specifies the data rate when
connected to another ClassPad, or a Data Analyzer. If the speed settings of
the ClassPad and the connected device are different from each other, the
slower setting is used.
Wakeup Enable: To turn on the wakeup function (see below), select “On*”. To turn off the wakeup function,
select “Off”. This setting is valid only the “3pin cable” is selected as the cable type.
select “Off”. This setting is valid only the “3pin cable” is selected as the cable type.
4. When all the settings are the way you want, tap [Set] to save them.
• The Communication application window appears at this time, with the new parameters you just configured.
Check to make sure the settings are the way you want.