3com 3C13880 Manual De Usuario
3Com Router 6000 Family
Installation Manual
Installation Manual
Chapter 6
Maintaining Hardware
3Com Corporation
6-2
Take these steps to remove a PSU, as shown in Figure 6-1:
Step 1: Remove the power cord connected to the PSU and loosen the two captive screws
fastening the module panel.
fastening the module panel.
Step 2: Hold the handle of the PSU and gently pull it out along the guides.
Caution:
If you do not plan to replace the PSU soon, install a blank filler panel to ensure
adequate ventilation and prevent dust.
adequate ventilation and prevent dust.
6.2.2 Installing a PSU
Step 1: Hold the handle of the PSU, gently push it into the chassis along the guides until it well
touches the power backplane inside the power slot.
touches the power backplane inside the power slot.
Step 2: Fasten the two captive screws in the PSU panel.
Step 3: Check that the power switch on the panel is on.
Step 4: Plug one end of the power cord shipped with the router into the socket on the PSU and
the other end to the power source.
the other end to the power source.
Step 5: Power on the router and check that the RUN LED on the RPU2 is ON.
6.3 Removing/Installing the Fan Module
The fan module is hot swappable and hold in a vertical slot on the right side of the chassis.
6.3.1 Removing the Fan Module
Figure 6-2
Remove the fan module
Step 1: Loosen the two captive screws on the fan module.
Step 2: Hold the handle on the fan module with one hand and its bottom with the other
hand. Pull part of the fan module out.
hand. Pull part of the fan module out.