Casio KL-G2 Manual De Usuario

■ Four cut modes

The printer has four cut modes.
• To specify a cut mode, perform step 5 under "Printing a Label" (page 20).

• Note that the cut method and margin length depends on the margin

settings.

• Regardless of the currently selected cut mode, full cutting and half cutting

are never performed while MARGINS NONE is specifi ed for the print format
(page 20).

• Tape cutting is not performed when the tape length is one of those shown in

the table below. In this case, you can use scissors or some other implement
to cut the tape after printing is complete.

MARGINS NARROW

MARGINS MEDIUM

MARGINS WIDE

Approximately 28mm
(1

") or less

Approximately 35mm
(1

") or less

Approximately 44mm
(1

") or less

■ CONT. HALF CUT

• CONT. HALF CUT performs a half cut between labels, and a full cut when

the end of the printing is reached.

Sal

■ FULL + HALF CUT

• FULL + HALF CUT perform a full cut at the end of each label, and a half

cut near the beginning of each label to make the backing paper easier to
remove.

Sal

■ FULL CUT

• FULL CUT performs a full cut at the end of each label.

• When using the NARROW and MEDIUM margin settings, this setting

automatically performs a full cut to trim off excess tape.

Sal

■ UNCUT

• When UNCUT is selected, the printer does not perform any cut operation

between labels.

• This setting is best when you want to print labels without spaces between

them, which saves label tape.

• After printing is complete, press FUNCTION and then

to feed the tape,

and then cut it with a pair of scissors.

Sal