Casio KL-G2 Manual De Usuario
52
EN
Part 10 - Reference
Power Requirements
Your printer can be powered using the specifi ed AC adaptor or by
commercially available alkaline batteries.
• Before using the printer, be sure to read the information under "Safety
commercially available alkaline batteries.
• Before using the printer, be sure to read the information under "Safety
Precautions" (pages 4 through 7).
Powering the Printer with Batteries
Use eight commercially available AA-size alkaline batteries to power the
printer.
• Use a full set of eight new alkaline batteries. Use of mixing old batteries with
printer.
• Use a full set of eight new alkaline batteries. Use of mixing old batteries with
new ones can result in a mismatch between the battery characteristics and
printer specifi cations, making batteries go dead before their normal service
life and causing malfunction of the printer.
printer specifi cations, making batteries go dead before their normal service
life and causing malfunction of the printer.
1.
Remove the battery cover on the
back of the printer.
back of the printer.
Do not try to force the battery cover
too far open or otherwise apply
undue force. Doing so can lead to
malfunction.
too far open or otherwise apply
undue force. Doing so can lead to
malfunction.
2.
Load the batteries.
Make sure the plus (+) and minus
(-) ends of each battery are facing in
the proper directions.
(-) ends of each battery are facing in
the proper directions.
3.
Close the battery cover.
Important!
• Batteries lose capacity at temperatures below 10°C (50°F), which can tend
• Batteries lose capacity at temperatures below 10°C (50°F), which can tend
to cause the message LOW BATTERY! to appear on the printer display.
Use the printer in a location within the operating temperature range of 10°C
to 35°C (50°F to 95°F).
Use the printer in a location within the operating temperature range of 10°C
to 35°C (50°F to 95°F).
• Do not disconnect the AC adaptor or remove batteries from the printer while
printer power is turned on. After turning off power, wait until the display
goes blank before disconnecting the AC adaptor or removing batteries.
Otherwise, temporarily stored text, text stored in printer memory, user
characters, copied text, or printer settings may be deleted.
goes blank before disconnecting the AC adaptor or removing batteries.
Otherwise, temporarily stored text, text stored in printer memory, user
characters, copied text, or printer settings may be deleted.
• If you are operating the printer under battery power and wish to connect or
disconnect the AC adaptor, be sure to fi rst turn off printer power. Connecting
or disconnecting with printer power on can cause it to turn off and delete
unsaved text you are working on.
or disconnecting with printer power on can cause it to turn off and delete
unsaved text you are working on.
Battery Life
Under normal conditions, a set of new batteries can supply enough power
to print labels for approximately two 18mm (
Under normal conditions, a set of new batteries can supply enough power
to print labels for approximately two 18mm (
3
/
4
") tape cartridges.
• Battery life can be extended by disabling the display backlight (page 51).
• Printing labels with large amounts of black text or images, low ambient
temperatures, and storing the printer for a long time with batteries
loaded can all shorten battery life.
loaded can all shorten battery life.
• Even if you do not use the printer, you should replace the batteries at
least once every two years.