Casio KL-G2 Manual De Usuario
55
EN
Error Messages
• ILLEGAL CHARACTERS!
• You are attempting to input and print characters that are not allowed
• You are attempting to input and print characters that are not allowed
for the bar code you are printing.
→ Re-input using proper characters. (page 39)
• LINK ERROR! CHECK ALL CONNECTIONS!
• The USB cable is not connected securely.
• LINK ERROR! CHECK ALL CONNECTIONS!
• The USB cable is not connected securely.
→ Secure and fully insert the USB cable into the connector.
• The computer is turned off.
• The computer is turned off.
→ Turn on your computer and then perform the operation.
• LOAD A TAPE CARTRIDGE
• There is no tape cartridge loaded in the printer or the current tape
• LOAD A TAPE CARTRIDGE
• There is no tape cartridge loaded in the printer or the current tape
cartridge was loaded improperly.
→ Correctly load the tape cartridge. (page 16)
• LOW BATTERY!
• Battery power is low.
• LOW BATTERY!
• Battery power is low.
→ Replace the batteries with new ones (sold separately) or use the
specifi ed AC adaptor. (pages 13, 52)
• Ambient temperature is below 10°C (50°F).
→ Use in the printer in a location within the operating temperature range
(10°C to 35°C; 50°F to 95°F).
• NOT ENOUGH MEMORY!
SET/ESC
• There is not enough memory for the data you are trying to save.
→ If you want to print without saving data, press SET and then continue
with the operation. To save the data, you fi rst need to delete unneeded
text data currently stored in memory. (page 40)
text data currently stored in memory. (page 40)
• NOW PRINTING (Appears when a print operation stops.)
• The printer has become overheated due to successive print
• The printer has become overheated due to successive print
operations.
→ Please wait without doing anything
Printing will resume when the printer returns to normal temperature.
• ODD NUMBER OF DIGITS!
• There is an odd number of input digits when printing an ITF bar code
• There is an odd number of input digits when printing an ITF bar code
with NO specifi ed for the check digit.
→ Re-input with a leading zero. (page 39)
• There is an even number of input digits when printing an ITF bar
• There is an even number of input digits when printing an ITF bar
code with YES specifi ed for the check digit.
→ Re-input with a leading zero. (page 39)
• PRINT ERROR! CHECK THE TAPE CARTRIDGE!
• Tape became jammed during printing.
• PRINT ERROR! CHECK THE TAPE CARTRIDGE!
• Tape became jammed during printing.
→ Turn off power, remove the tape cartridge, and clear the jammed tape.
(page 17)
• The tape auto cutter is jammed with foreign matter.
→ Turn off power, remove the tape cartridge, and clear whatever is jammed
in the auto cutter. (page 17)
• Dirt, tape cuttings, or other foreign matter adhering to the rubber
roller.
→ Remove anything adhering to the rubber roller and clean the roller.
(page 53)
• Tape cuttings or other foreign matter is adhering to the sensor in the
tape compartment.
→ Clear the foreign matter from inside in the tape compartment. (page 53)
• PRINTER NOT SHUT DOWN PROPERLY LAST TIME
• The last time the printer was used, the AC adaptor was disconnected
• PRINTER NOT SHUT DOWN PROPERLY LAST TIME
• The last time the printer was used, the AC adaptor was disconnected
or power to the printer was otherwise abnormally cut off.
→ Press any key to initialize the data that was partially deleted the last time
the printer powered down. (page 13)