Dialogic 6.2 Manual De Usuario

About Plug and Play Components

November 2009

391

You cannot start or stop the Plug and Play driver 

using commands like the net start/stop commands that 

you might be using in your application. The user cannot restart 

the driver since it is now a Windows® Device Manager Plug 

and Play driver. For any change requiring a driver restart, 

such as change in history size and debug options, you must:

Š

Check for the current state of the service

Š

Tell the user to restart Windows® if the driver is not 

started

You can install and uninstall the PnP driver using install.exe 

application that is already installed with the Brooktrout Fax 

Software.

Dialogic does recommend that the only driver settings that you do 

change are the History Enable, and History Size. However, your 

changes will only take effect by rebooting the system or by using the 

Brooktrout Configuration Tool. You can run the Configuration Tool 

in silent mode for the changes to take effect. You do not need to run 

it in Advanced mode.

As stated earlier, Microsoft leaves few interfaces for the hardware 

vendor to implement. 

 summarizes the components for these 

interfaces.