HP (Hewlett-Packard) 441877-00F Manual De Usuario
Installation 13
Parameter Options
Description
CheckSum =
Default = ON
Selections are: ON, OFF, Tx,
Rx
Selections are: ON, OFF, Tx,
Rx
Enables or disables the transmit and receive
checksum off-loading feature. Checksum is
checksum off-loading feature. Checksum is
supported under NetWare 5.x only. If you
want to enable the CheckSum parameter, you
need to load it on the first instance.
need to load it on the first instance.
Frame = type
Valid types are:
Ethernet_802.2,
Ethernet_802.2,
Ethernet_802.3, Ethernet_II,
Ethernet_SNAP
Defines the frame type being used by this load
instance. Ethernet_802.2 and Ethernet_II are
instance. Ethernet_802.2 and Ethernet_II are
the default values.
node =
NNNNNNNNNNNN
Specifies a node address in this field to
override the default Media Access Controller
override the default Media Access Controller
(MAC) address (also known as the Locally
Administered Address)
Administered Address)
name = text
Displays the name assigned to this adapter
PDriver =
Default = OFF
Selections are: OFF, ON
Selections are: OFF, ON
Allows driver to operate in persistent driver
mode. Persistent driver mode is supported
mode. Persistent driver mode is supported
under NetWare 5.x only. Use only if adapter
is placed in a Hot Plug PCI slot and only if
is placed in a Hot Plug PCI slot and only if
required to swap with an exact board.
RxBuffers =
Default = 200
Recommended Min = 32
Max = 512
Min = 1 when used with DOS
Client32 and when Keywrod
Recommended Min = 32
Max = 512
Min = 1 when used with DOS
Client32 and when Keywrod
P3-1 or 2.
Pre-allocates ECB resources on the adapter for
receiving packets
receiving packets
TxDescriptors =
Default = 200
Recommended Min = 100
Max = 512
Recommended Min = 100
Max = 512
Min = 1 when
used with DOS
used with DOS
Client32 and when
Keywrod P3-1 or
2.
Pre-allocates ECB resources on the adapter for
transmitting packets.
transmitting packets.
RxFlow =
Default = OFF
Selections are: ON, OFF
Selections are: ON, OFF
Allows enabling/disabling of RxFlow control.
TxFlow =
Default = OFF
Selections are: ON, OFF
Selections are: ON, OFF
Allows enabling/disabling of TxFlow control.
Slot = n
Identifies the slot number for the specific
adapter currently being configured. This
adapter currently being configured. This
parameter is not necessary if only a single
adapter is installed.
Speed = n
If link negotiation has been disabled, specifies
port speed to be either Auto, 10HD or 10FD,
100HD or 100FD.
100HD or 100FD.