Cisco Systems PRP-1= Manual De Usuario
Upgrading to the PRP
32
Performance Route Processor Installation and Configuration Guide
OL-11656-01
Figure 9
PRP-2 LEDs (Partial Front Panel View)
The PRP-2 has the following LED indicators:
•
Two Flash disk activity LEDs, one for each Flash disk slot (labeled SLOT-0
and SLOT-1)—Identify which of the Flash disk slots is accessed.
and SLOT-1)—Identify which of the Flash disk slots is accessed.
•
Two Ethernet port LEDs used in conjunction with each of the three RJ-45
Ethernet connectors:
Ethernet connectors:
–
LINK—indicates link activity
–
DATA—indicates data transmission or reception
•
Two BITS port LEDs used in conjunction with each of the two BITS ports:
–
SIG—indicates carrier signal available
–
ACT—indicates the interface is active
Upgrading to the PRP
This section details how to upgrade from the GRP to the PRP. The procedures
described are the same whether you are upgrading to a PRP-1 or PRP-2.
described are the same whether you are upgrading to a PRP-1 or PRP-2.
•
•
•
AC
T
SIG
AC
T
SIG
SLO
T-
1
SLO
T-
0
ETH 2
BITS 1
BITS 0
DATA
LINK
DATA
LINK
ETH 1
ETH 0
101108