Polycom MX392 Manual De Usuario
Make sure that the physical wiring works by pressing the membrane switch. You should see the
LED above the pin assignment lit in green:
LED above the pin assignment lit in green:
Repeat the above process for each MX392 microphone that you want to connect to the Vortex
Device.
Device.
L
OGIC
O
UTPUT
Go to the Logic Output page of Conference Composer. If the LED IN wire is connected to Logic
Output pin 1, then you need to assign Pin 1 by left-clicking the desired pin in the DB-25 graphic.
The pin will turn color from gray to pink. Next, right-click on the pin and reverse the polarity. A
horizontal bar should appear under the pin number in the DB-25 graphic and under the pin number
under the Pin column:
Output pin 1, then you need to assign Pin 1 by left-clicking the desired pin in the DB-25 graphic.
The pin will turn color from gray to pink. Next, right-click on the pin and reverse the polarity. A
horizontal bar should appear under the pin number in the DB-25 graphic and under the pin number
under the Pin column:
Reversing the polarity is critical to proper operation. When S3 is in the ON position, the MX392
wants to see an Active Low signal (0V DC) from the Vortex Device in order to illuminate the LED.
By default, the EF Device has been designed to assume that an Active High signal (+5V DC) is
required to drive an LED. The MX392 uses the active low signal to use part of the phantom power
voltage to illuminate the LED. If you do not reverse the polarity, the LED will light up exactly the
opposite way you will have intended.
wants to see an Active Low signal (0V DC) from the Vortex Device in order to illuminate the LED.
By default, the EF Device has been designed to assume that an Active High signal (+5V DC) is
required to drive an LED. The MX392 uses the active low signal to use part of the phantom power
voltage to illuminate the LED. If you do not reverse the polarity, the LED will light up exactly the
opposite way you will have intended.
10