Royal Sovereign RSS-1050 Manual De Usuario

6. It is ready when the LCD window shows 

9.Push 

11. Push

 

 

 

 

 

4. Set pressure lever to "Laminating" position.
5. Increase temperature of the hot shoe. If the temperature is memorized for the

   button to choose the correct location.

7. To set the film tension properly, please use the Tension Adjustment Knob while

3. Turn on the power switch on the backside of the product. (Emergency Switch must
   be turned to the "OFF" position.

1. Properly plug in the machine.
2. Set up your film.

   the better operation.)

   side for perfect laminations.

13. The document, which has been just laminated, is pretty hot and easily bent.

8. Set documents on the table. (You should allow at least 5mm(1/4") room on each 

on the control panel. If the rollers don't run, please check

   the emergency switch whether it is located at "ON" position or not. 

   laminator, please push                 button, then use                 or

   and the buzzer rings sound

   three times. (It takes about 10minutes depending on setting temperature.)

14. After finishing your work(laminating), change the position of the Pressure Lever

10. Push document into the rollers and start laminating.

   when the laminating is finished. Cut the document with the cross

   cutter, if needed.

   you are checking laminating condition (The lower film tension would make 

12. It would be convenient, if the table guide is set at the proper position  when

   from the left/right side of the object with the Slitters.

   Try not to touch the document until it has cooled down.

   the machine is continuously laminating. It is possible to cut unnecessary excess

15. Turn the Power switch off.

   to "Hard Board, 1mm(40mil)".

RUN

STOP

MEMORY

 

- 18 -