SEAL 600-C Manual De Usuario

S E T - U P A N D O P E R A T I O N

SETTING THE UNWIND BRAKE TENSION

IMPORTANT! The brake tension greatly
affects the smooth flow of the laminating film.

•

Turning the unwind brake in a counter-clockwise
direction increases the braking tension applied on

the laminate.

•

Turning the unwind brake in a clockwise direction

decreases the braking tension.

•

The best setting for the unwind brake tension is
determined by the materials you are using and is

learned through experience.

Figure 6. Unwind Brake

LOADING A ROLL OF MATERIAL

IMPORTANT! Make sure to fully release brake

tension whenever changing a roll of film.

•

Swing out the desired unwind shaft towards you
and use the 5/16 T-handle to loosen the setscrew

and remove the Lock Collar from the unwind shaft.

•

Slide a roll of material onto the unwind shaft and

replace the lock collar.

IMPORTANT! Make certain that you place the

roll of film on the unwind shaft so that the
material will feed with the adhesive side facing

away from the rollers.

•

Press the unwind shaft firmly back into the receiver
to prevent tension and tracking problems.

•

Center the films on the unwind shafts. Measure the
distance from the face of the cabinet and the film

edges (not the cores) and adjust until they are equal.
IMPORTANT! The position of all films,

boards, rolls of media and cardboard cores for
wind-ups must be set central in the laminator to

ensure optimum quality and correct tracking.

•

Adjust the brakes and lock collars flush against the

roll ends and tighten the setscrews.
IMPORTANT! Do not over-tighten the

setscrews to prevent stripping the threads.

Figure 7. Loading Roll of Material

Unwind
Shaft film
goes on this
side of brake

Tension ring

Brake tension is fully
released when the tension
ring and collar gap is closed

Brake Collar

Adhesive Side

Brake Side

Lock Collar