Motorola MT2090 Manual De Usuario
User Preferences & Miscellaneous Scanner Options 5 - 13
Timeout Between Decodes, Same Symbol
Parameter # 89h
Use this option in presentation mode to prevent the beeper from continuously beeping when a symbol is left in the
device’s field of view. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is
0.5 seconds.
device’s field of view. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is
0.5 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric bar
codes from
codes from
that correspond to the desired interval, in 0.1 second increments.
Hand-Held Decode Aiming Pattern
Parameter # F0h, 32h
This parameter only applies in Decode Mode. Select Enable Hand-Held Decode Aiming Pattern to project the
aiming pattern during 1D bar code capture; Disable Hand-Held Decode Aiming Pattern to turn the aiming pattern
off.
aiming pattern during 1D bar code capture; Disable Hand-Held Decode Aiming Pattern to turn the aiming pattern
off.
Timeout Between Decodes, Same Symbol
NOTE
With
enabled, the decode aiming pattern flashes even when the Decode
Aiming Pattern is disabled.
*
Enable Hand-Held Decode Aiming Pattern
(02h)
Disable Hand-Held Decode Aiming Pattern
(00h)