Fujitsu 480 Manual De Usuario

8-52

C122-E003-02EN

GSWB
CHAPTER 8 CLI Operations

 

Action: Check the entries already registered.

• % Not implement daughter card.

Cause: 10GigabitEthernet was specified for the port while no TenGigaEthernet 

daughter card was implemented.

Action: Check the device configuration.

• It is necessary to review specified VLAN and port.

Cause: The VLAN and port definitions do not match.

Action: Review the VLAN and port definitions.

• Entry isn't existed.

Cause: The specified entry is not registered.

Action: Check the entered MAC address entry.

• mac address table is full.

Cause: The MAC address table is full.

Action: Wait until the MAC address table has a free space and then enter the 

command again.

• Input parameter error.

Cause: An invalid parameter was specified.

Action: Specify the correct parameter.

This command enables or disables STP for the whole device.

If BPDU frame transfer is enabled by the spanning-tree bpdufilter command, this 
command cannot enable STP.  To enable STP, disable BPDU frame transfer.

• Enables STP for the whole device (default)

• Disables STP for the whole device

spanning-tree