Barco MFGD 3621 Manual De Usuario

B

ARCO

M

ED

 C

ORONIS

 display controller installation

33

Figure 5: PCI and RAID Controller Slots

Install the BarcoMed Coronis controller in your computer 
following these steps:

Turn off the power to your computer and disconnect the power 
cord, however make sure that the computer chassis is still 
grounded.

Remove the chassis cover according to the manufacturer’s 
instructions. Be sure to observe safety warnings.

If you have decided to use the on-board VGA capabilities of the 
BarcoMed Coronis (see Using the VGA capabilities of the 
BarcoMed Coronis on page 32), you must now remove any VGA 
display controller(s) that are currently installed in the computer or 
disable any VGA controllers that are integrated into your PC’s 
motherboard.

Install the BarcoMed Coronis Controller into a free PCI slot, either 
64-bit or 32-bit (see figure 5,  for examples of slots).  Be sure that 
the display controller is seated firmly in the slot.

Secure the card to the chassis with the PC’s I/O panel mounting 
screw, and replace the chassis cover.

Connect the primary display (left most display in a linear 
configuration, top most in a vertical configuration) to the 
uppermost connector on the BarcoMed Coronis (the output farthest 
from the motherboard – “Head 1” in figure 6) using the provided