Benq MX716 Manual De Usuario

Operation

34

1.

Go to the SYSTEM SETUP: Basic > Panel Key Lock menu, and select On by 
pressing 

/  on the projector or remote control. A confirmation message 

displays. 

2.

Highlight Yes and press ENTER to confirm.

To release panel key lock, use the remote control to enter the 

Basic > Panel Key Lock menu and press 

/

 to select 

Off.

• 

Keys on the remote control are still active when panel key lock is enabled.

• 

If you turn off the projector without disabling panel key lock, the projector will still be in locked status the 

next time it is turned on.

We recommend you use the High Altitude Mode when your environment is between 

1500 m –3000 m above sea level, and ambient temperature is between 0°C–35°C.

Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and ambient temperature is 

between 0°C and 35°C. The projector will be over cooled, if you turn the mode on under such a condition.

To activate the High Altitude Mode:

1.

Press MENU/EXIT and then press  /  until the SYSTEM SETUP: Advanced 
menu is highlighted.

2.

Press  

to 

highlight 

High Altitude Mode and press 

/

 select On. A 

confirmation message displays.

3.

Highlight Yes and press ENTER.

Operation under "High Altitude Mode" may cause a higher decibel operating noise level 

because of increased fan speed necessary to improve overall system cooling and 

performance.

If you use this projector under other extreme conditions excluding the above, it may 

display auto shut-down symptoms, which is designed to protect your projector from over-

heating. In cases like this, you should switch to High Altitude mode to solve these 

symptoms. However, this is not to state that this projector can operate under any and all 

harsh or extreme conditions.

In addition to selecting the projector preset startup screen from among BenQ logo, Black 

or Blue screen, you can make your own startup screen that is a picture projected from 

your computer or video source.
To create your own startup screen, project the picture you want to use as your startup 

screen from either a computer or video source. The rest steps are as follows.

•  Using the remote control
1.

Press CAPTURE on the remote control. 

2.

A confirmation message is displayed. Press CAPTURE or ENTER again.

3.

The message 'Screen Capturing...' is displayed while the projector is processing 
the picture. Please wait.

4.

If the action is successful, you see the message 'Captured Succeeded' on the 
screen. The captured picture is saved as My Screen.

5.

To view the captured picture displayed as the startup screen, set My Screen in the 
SYSTEM SETUP: Basic > Splash Screen menu and restart the projector.