ATTO Technology 2500C Manual De Usuario

Descargar
Página de 77
6
Installation: ATTO iPBridge 2500C
 1.2  ATTO iPBridge 2500C
The ATTO iPBridge 2500C is a 1-Gigabit Ethernet to SCSI embeddable cPCI bridge for high 
performance, cost effective solutions in enterprise environments. 
The iPBridge 2500C includes two Ethernet data 
ports, an Ethernet management port which may be 
used as a data port in the iPBridge 2500 iSCSI-
configured model, a serial management port and 
two SCSI ports. It includes a battery-backed Real-
Time-Clock, and an IP Time client (RFC 1631 
compliant).
Dimensions
Width:  
6.193 inches 
Length:  
6.375 inches 
Height of tallest component:  
.535 inches
Environment
Operating Temperature:  
0-70°C external
Ambient air should not exceed 40°C.
User-configurable thermal sensor  
for automatic 
shutdown default is 70°C
Humidity:  
10-90% non-condensing
Recommended airflow:  
11 cubic feet per minute
Power 
The iP2500C board may be powered from the 
cPCI backplane or a 6-pin connector. 
Input voltage:  
5.0V DC ±5% derived from cPCI 
or 6-pin connection. Fused at the backplane and 
hot swap protection.
Power draw:  
3 amps at 5.0V DC. Battery-backed 
event log SRAM: A rechargeable Lithium ion 
battery cell or Super Cap holds the memory in a 
512KB SRAM based on the following chart. 
Recharging begins automatically when power is 
restored to the system. 
WARNING
Risk of explosion if the battery is removed 
and/or replaced by an incorrect type. 
Dispose of used batteries in accordance 
with your local environmental regulations.
SCSI interface
The two independent SCSI ports on the iPBridge 
2500C connect storage devices into the Ethernet 
Storage Area Network (SAN). Each port is 
completely independent.
The ports are Ultra 3 LVD/SE SCSI busses with 
68-pin “P” interface: 160 MB/sec. maximum 
throughput, downward compatible with all forms 
of single-ended SCSI.
The iPBridge supports all SCSI devices including 
hard disk drives, tape drives, RAID controllers 
and DVD, MO and CD libraries.
Ethernet interface
The two independent 10/100/1000 GbE RJ45 data 
ports, labeled Ethernet port 0 and Ethernet port 1, 
use the Intel 8254x family gigabit Ethernet 
chipset to support telnet-based data transfer. A 
separate 10/100/1000 Ethernet standard RJ45 
management port, labeled Ethernet port 2 and 
which may be used as a data port in the iPBridge 
2500 iSCSI-configured model, provides 
monitoring and management through ATTO 
ExpressNAV, a browser-based interface.
Time to charge 
battery or CAP
Backup power 
duration
Battery 
(typical)
36 hours 
continuous power
30 days
Super CAP 
worst case
60 seconds
3 hours
Super CAP 
typical
>320 seconds
5-15 hours