ATTO Technology 2500C Manual De Usuario

20

Configuration: additional modes

1

If you have not already, open an ExpressNAV 
session. For instructions, refer to 

2

Determine the current speed and transfer rates: 
type at the SCSI page.

3

SCSI Port Bus Speed controls the transfer rate 
at which the iPBridge attempts to negotiate with 
its SCSI devices. Default is Ultra3. Complete 
the appropriate settings.

4

SCSI Port Sync Transfer specifies whether 
synchronous SCSI transfers should be 
negotiated with devices on the specified SCSI 
port. The default is enabled. Change the setting 
if desired.

SNMP protocol
Remote system monitoring is available using 
Simple Network Management Protocol (SNMP). 
An agent resides in the iPBridge which takes 
information from the iPBridge and translates it 
into a form compatible with SNMP. If certain 
conditions arise, the agent sends asynchronous 
notifications (traps) to a client.

 on page 42 for 

detailed information on the commands which 
regulate SNMP on the iPBridge.

Contact your network administrator for the MIB 
software and appropriate MIB file for your 
iPBridge. Use the SNMP page of the 
ExpressNAV interface to enable traps or extended 
traps.