ATTO Technology 2500C Manual De Usuario
53
ATTO Technology Inc. iPBridge Installation and Operation Manual
7.1.8 NDMP commands
If your iPBridge has been configured for NDMP, default settings to the two iPBridge Ethernet data ports
may be customized to your specifications using the CLI commands in this section.
may be customized to your specifications using the CLI commands in this section.
Note
For NDMP-configured iPBridge 2500 models
only
only
NDMPAuthType
Controls the security level used by the iPBridge for
NDMP authentication for all ports.
Controls the security level used by the iPBridge for
NDMP authentication for all ports.
Default: none
Set syntax: set NDMPAuthType [none | text | md5]
Requires a SaveConfiguration command
Get syntax: get NDMPAuthType
Set syntax: set NDMPAuthType [none | text | md5]
Requires a SaveConfiguration command
Get syntax: get NDMPAuthType
NDMPMaxVersion
Controls the highest NDMP version to which the
iPBridge negotiates for each Ethernet data port.
Controls the highest NDMP version to which the
iPBridge negotiates for each Ethernet data port.
Default: 4
Set syntax: set NDMPMaxVersion [DPn | all] [3 | 4]
Requires a SaveConfiguration command
Get syntax: get NDMPMaxVersion
Set syntax: set NDMPMaxVersion [DPn | all] [3 | 4]
Requires a SaveConfiguration command
Get syntax: get NDMPMaxVersion
NDMPPortNumber
Controls the NDMP port number that to be used by the
iPBridge for each Ethernet data port.
Controls the NDMP port number that to be used by the
iPBridge for each Ethernet data port.
Default: 10000
Set syntax: set NDMPPortNumber [DPn | all] [PortNum]
Requires a SaveConfiguration command
Get syntax: get NDMPPortNumber
Set syntax: set NDMPPortNumber [DPn | all] [PortNum]
Requires a SaveConfiguration command
Get syntax: get NDMPPortNumber
NDMPStatus
Shows status of all NDMP servers, including mover
servers. The server name is not mutually exclusive, i.e.,
the same server name may apply to a mover and
tape/SCSI service at the same time.
Shows status of all NDMP servers, including mover
servers. The server name is not mutually exclusive, i.e.,
the same server name may apply to a mover and
tape/SCSI service at the same time.
ServerName - Device connection name
Port - Ethernet port number [0|1]
Type - tape, mover, SCSI
Host - IP address of host connection
State - [idle | listen | active | paused | halted]
Port - Ethernet port number [0|1]
Type - tape, mover, SCSI
Host - IP address of host connection
State - [idle | listen | active | paused | halted]
Immediate command: NDMPStatus