Cisco Systems OL-16146-10 Manual De Usuario

  1  Pass

  2  Pass

  3  Pass

 3/2 Pass

  4  Pass

  5  Pass

  6  Pass

Router#

Router2#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

PE2(config)#no power enable module 6

PE2(config)#end

PE2#

*May 15 10:30:54.227 UTC: %SYS-5-CONFIG_I: Configured from console by console

PE2#

*May 15 10:30:53.325 UTC: %C6KPWR-SP-4-DISABLED: power to module in slot 6 set off (admin 

request)

Router#

The Cisco 7600 series routers support OIR of a SFP or XFP modules independently of removing the 
Cisco 7600 Series ES+ line card. This means that a Cisco 7600 Series ES+ line card can remain installed 
in the router with one XFP remaining active, while you remove another XFP from one of the line card 
ports. Or, that an Cisco 7600 Series ES+ line card can remain installed in the router with some number 
of SFP modules remaining active, while you remove other SFP modules from the line card ports.

The interface configuration is retained (recalled) if a Cisco 7600 Series ES+ line card or SFP or XFP is 
removed and then replaced with one of the same type. 

If you are planning to remove a Cisco 7600 Series ES+ line card along with its SFP or XFP modules, 
then you do not need to follow the instructions in this section. To remove a Cisco 7600 Series ES+ line 
card, see the 

.

The SFP and XFP modules support online insertion and removal (OIR). However, if the line card is 
already installed in the router and the system is operational, we recommend that you administratively 
shut down the SFP or XFP module port before installing a new module.