Cisco Systems PA-POS-1OC3 Manual De Usuario
C H A P T E R
2-1
PA-POS-1OC3 Single-Port Port Adapter Installation and Configuration Guide
OL-6514-04
2
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-POS-1OC3. This chapter contains the following sections:
PA-POS-1OC3. This chapter contains the following sections:
•
•
•
•
•
Required Tools and Equipment
You need the following tools and parts to install the PA-POS-1OC3. If you need additional equipment,
contact a service representative for ordering information.
contact a service representative for ordering information.
•
PA-POS-1OC3, or PA-POS-1OC3=
•
One LC-type duplex or two LC-type simplex, multimode, or single-mode optical fiber cables to
connect the interface with the network. (Single-mode and multimode optical fiber cables for the
PA-POS-1OC3 are not available from Cisco Systems but are available from commercial cable
vendors. For information about optical fiber cables, see the
connect the interface with the network. (Single-mode and multimode optical fiber cables for the
PA-POS-1OC3 are not available from Cisco Systems but are available from commercial cable
vendors. For information about optical fiber cables, see the
and the
.)
•
Phillips screwdriver (1 or 2)
•
Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
strap included with all upgrade kits, field-replaceable units (FRUs), and spares
•
Antistatic mat
•
Antistatic container