Cisco Systems 694 Manual De Usuario
5-11
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
Chapter 5 WAVE Interface Modules
Installation Scenarios and Cabling Examples for Fast Ethernet Connections
Two WAVE appliances with inline network adapters can also be installed back-to-back in a serial fashion
between two network devices for failover purposes. In this serial cluster configuration, if one WAVE
appliance fails, the other WAVE appliance can provide optimization. (See
between two network devices for failover purposes. In this serial cluster configuration, if one WAVE
appliance fails, the other WAVE appliance can provide optimization. (See
.)
Note
When you connect two WAVE inline appliances to each other serially, always use a crossover cable
between the two WAVE appliances. (See
between the two WAVE appliances. (See
.)
Figure 5-10
Cabling for a Single Inline WAVE Appliance with Redundant WAN Connections
1
Connection: Management
Gigabit Ethernet: 1/0
Cable type: Straight-through (recommended)
2
Connection: WAVE to LAN switch
(using InlineGroup 1/0)
Fast Ethernet: LAN0 (InlinePort 1/0/lan)
Cable type: Straight-through
3
Connection: WAVE to LAN switch
(using InlineGroup 1/1)
Fast Ethernet: LAN1 (InlinePort 1/1/lan)
Cable type: Straight-through
4
Connection: WAVE to WAN router A
(using InlineGroup 1/0)
Fast Ethernet: WAN0 (InlinePort 1/0/wan)
Cable type: Crossover
5
Connection: WAVE to WAN router B
(using InlineGroup 1/1)
Fast Ethernet: WAN1 (InlinePort 1/1/wan)
Cable type: Crossover
MGMT
243288
WAVE
WAN
WAN
Router A
Router B
LAN switch
1
4
5
2
3