Compaq NetPorty II Manual De Usuario
Troubleshooting &
Techn. Support
What to do if you have problems
Version 1.03
4-3
4.1.1
Solutions for all parts ...
The system crashes after choose the hardware at
PcCANControl:
PcCANControl:
The selected memory area is not free, or the
selected interrupt is being used by another
application. Make sure that no conflicts exist on
your system. If you get a blue screen under Win
NT it is most likely that a memory or IRQ conflict
is occur.
selected interrupt is being used by another
application. Make sure that no conflicts exist on
your system. If you get a blue screen under Win
NT it is most likely that a memory or IRQ conflict
is occur.
PcCANControl launches correctly, but CAN access
is not possible:
is not possible:
Check the transceiver cable and CAN
connectors. If a connector is not correctly
plugged, connect it right. If the sub-min-D
connectors at the end of the cables are hot,
remove the Key and call I+ME.
If you use higher baudrates, remember to
protect the end of line with resistors [120Ohm]
connectors. If a connector is not correctly
plugged, connect it right. If the sub-min-D
connectors at the end of the cables are hot,
remove the Key and call I+ME.
If you use higher baudrates, remember to
protect the end of line with resistors [120Ohm]