Cisco Systems MEM-16F-RSP4+= Manual De Usuario
13
RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide
78-12288-02
Installing the SIMM
Figure 5
Handling a SIMM
Caution
To prevent ESD damage, handle the edges of the SIMM only; avoid touching the memory
module, pins, or traces (the metal fingers) along the socket edge.
module, pins, or traces (the metal fingers) along the socket edge.
Step 5
Place the SIMM in an antistatic bag to protect it from ESD damage.
This completes the SIMM removal procedure. Proceed to the next section to install the new SIMM.
Installing the SIMM
After removing the 8-MB SIMM, use the following procedure to install the 16-MB SIMM.
Step 1
Position the RSP4+ so that the handle is away from you and the bus connector is toward you—opposite
of the position shown in Figure 2.
of the position shown in Figure 2.
Step 2
Locate the memory SIMM socket for the insertion. The SIMM occupies socket U1. (See Figure 3.)
Step 3
Hold the SIMM between your thumbs and forefingers, component-side-up, with the connector edge
(the metal fingers) away from you. (See Figure 5.)
(the metal fingers) away from you. (See Figure 5.)
Note
SIMMs have a polarization notch to prevent them from being installed backwards. Hold the
SIMM with the connector edge at the bottom. (See Figure 6.)
SIMM with the connector edge at the bottom. (See Figure 6.)
Figure 6
SIMM Polarization Notch
Step 4
Tilt the SIMM to approximately the same angle as the socket and insert the connector edge into the
socket.
socket.
49598
Alignment holes
Connector edge
Polarization notch
H2407