Cisco Systems MEM-16F-RSP4+= Manual De Usuario

Boot the router, and allow it to initialize.

Use the enable command to enter privileged mode so you can configure the new 16MB bootflash:

Router> en

Password:

Router#

Use the show version command to confirm the size of the bootflash. The following example shows an
16MB bootflash output:

Router#sh ver

Cisco Internetwork Operating System Software

IOS (tm) RSP Software (RSP-JSV56I-M), Version 12.1(3)T,  RELEASE SOFTWARE (fc1)

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Wed 19-Jul-00 22:18 by ccai

Image text-base: 0x60010968, data-base: 0x618D2000

ROM: System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)

BOOTFLASH: RSP Software (RSP-BOOT-M), Version 12.0(8)S, EARLY DEPLOYMENT RELEAS)

doc-7507 uptime is 12 weeks, 3 days, 21 hours, 29 minutes

System returned to ROM by bus error at PC 0x60330F20, address 0x6229

System image file is "slot0:rsp-jsv56i-mz.121-3.T"

cisco RSP8 (R7000) processor with 131072K/8216K bytes of memory.

R7000 CPU at 250Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache

Last reset from power-on

G.703/E1 software, Version 1.0.

G.703/JT2 software, Version 1.0.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

Bridging software.

TN3270 Emulation software.

Chassis Interface.

1 VIP2 controller (1 FastEthernet).

1 FastEthernet/IEEE 802.3 interface(s)

2043K bytes of non-volatile configuration memory.

20480K bytes of Flash PCMCIA card at slot 0 (Sector size 128K).

16384K bytes of Flash internal SIMM (Sector size 256K).

No slave installed in slot 3.

Configuration register is 0x102

Use the format bootflash command to format the bootflash memory, as shown in the following
example:

Router#format bootflash:

Format operation may take a while. Continue? [confirm]

Format operation will destroy all data in "bootflash:".  Continue? [confirm]

Formatting sector 1

Format of bootflash complete

Router#