Cisco Systems CX-TRIP2 Manual De Usuario
26 Token Ring Interface Processor (TRIP) Installation and Configuration
Upgrading Microcode
Step 5
Confirm that you want the file copied into Flash:
Copy trip1-0 from 131.108.13.111 into flash memory? [confirm] yes
Step 6
If you do not want the other microcode files in Flash memory erased, enter no
OR
If you want Flash erased, enter yes.
Erase flash before writing? [confirm] no
If you answered yes, the Flash memory is erased, and the TRIP microcode is copied to
Flash memory. Output similar to the following is displayed:
Flash memory. Output similar to the following is displayed:
Zeroing bank...zzzzzzzzzzzzzzzz
Verify zeroed...vvvvvvvvvvvvvvvv
Erasing bank...eeeeeeeeeeeeeeee
Loading from 131.108.1.111: !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
[OK - 1906676/4194240 bytes]
Verifying via checksum...
Flash verification successful. Length = 1906676, checksum = 0x12AD
If you answered no, the TRIP microcode is copied to Flash memory without any erasure of
existing files in Flash.
existing files in Flash.
Step 7
Verify that the microcode has been copied to Flash memory:
Router# show flash
The following type of output is displayed:
4096K bytes of flash memory on embedded flash (in RP1).
file offset length name
0 0x40 53330 trip1-0
1 0xD0D4 51432
sp140-34
[4089412/4194304 bytes free]
Step 8
If you want the TRIP to use the microcode in Flash memory immediately, enter the
following commands at the router prompt:
following commands at the router prompt:
Router# microcode trip flash
microcode file name
Router# microcode reload
The microcode reload command immediately enables the TRIP to use the specified
microcode file.
microcode file.
Step 9
To ensure that the new microcode is used by the TRIP after a system reboot, add the
microcode commands to the configuration file. To access the configuration file, enter the
following command:
microcode commands to the configuration file. To access the configuration file, enter the
following command:
Router# configure terminal
Step 10
Add the following commands to the configuration file:
microcode trip flash
microcode file name
microcode reload
Step 11
To exit the configuration mode, press Ctrl-Z.
Step 12
To write the updated configuration file to the NVRAM, enter the following command:
Router# copy running-config startup-config