Cisco Systems H.323 Manual De Usuario

After the HSI software is installed, you can configure additional items. The following MML command 
examples show how to enable DTMF capability on the HSI. (For a description of the sys_config_static 
entry and the dtmf parameters, please see the section (

The following MML command example shows how to start an MML session and enable DTMF support 
of the HSI:

As root user, issue the following command:

As mgcusr, begin an MML session by issuing the following command: 

mml

To enable DTMF support on the HSI, issue the following set of commands:

 

The preceding command creates a new configuration, based on the current configuration, called 
myconf.

Certain configuration changes do not take effect until the HSI is restarted. After the 
restart-softw command is issued, the HSI restarts in approximately 20 seconds.

Use MML commands to perform all HSI configuration. Never manually edit system configuration files 
because they do not undergo the same parse checks as MML commands. In addition, the HSI uses a 
machine-generated checksum to verify the system files. If you modify the system configuration files 
manually, the HSI cannot use them and reverts to the base configuration.

The following MML command examples show how to verify that configuration changes have been 
correctly processed:

To retrieve information about the current provisioning session, issue the following command:

 

The HSI prints an asterisk next to the currently active configuration.