Cisco Systems 100/200/300/400 Manual De Usuario

For the CDE100, use the internal CD-ROM drive for recovery or remanufacture procedures.

 

 
For the CDE200, do not use the internal CD-ROM drive for recovery or remanufacture procedures. Use 
the external USB CD-ROM drive for all procedures that require a CD-ROM drive.

You also need to configure the ports on the CDE200 as shown below:

The two built-in Gigabit Ethernet ports are GigabitEthernet

 

1/0 and GigabitEthernet 2/0 and are 

management ports using channel bonding 1 (see 

).

The four interface ports on the stream interfaces are GigabitEthernet 3/0, GigabitEthernet 4/0, 
GigabitEthernet 5/0 and GigabitEthernet 6/0 using channel bonding 2 (see 

Perform the initial installation and configuration of your CDS network in the following order:

Run the BIOS setup utility on each CDE in the CDS network.

Install the CDS Release 2.0-2.1 software on each CDE in the CDS network.

Configure the CDSM.

It is very important that the onboard SCSI controller be disabled on the CDE200. Do this by physically 
opening the CDE200 case (by removing two side screws and a back thumbscrew), and verifying that the 
jumper labeled “JPA-1” (located about two inches below the center PCI-X slot—slot 3 of 5) has pins 2 
and 3 connected (instead of 1 and 2). Pin 1 is closest to the rear of the case and pin 3 is closest to the front.

Running the BIOS setup utility is different for the CDE100 and the CDE200; therefore, this section 
provides a separate BIOS setup procedure for each CDE.

eth0

 g1/0

eth1

 g2/0

eth2

g3/0

eth3

g4/0

eth4

g5/0

eth5

g6/0