Cisco Systems 512 Manual De Usuario
Chapter 4 Installing Hardware Options
Working with Hard Disk Drives
4-12
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
OL-9137-02
Installing an SAS Hard Disk Drive
Note
The WAE-612 hardware supports hot-swappable SAS hard disk drives; however,
you must be running WAAS 4.0.13 or a later version to obtain the software
support for hot-swapping. If you are running a WAAS version prior to 4.0.13, we
recommend that you power down your WAE-612 when swapping or installing
new hard disk drives.
you must be running WAAS 4.0.13 or a later version to obtain the software
support for hot-swapping. If you are running a WAAS version prior to 4.0.13, we
recommend that you power down your WAE-612 when swapping or installing
new hard disk drives.
To install an SAS hard disk drive in the WAE-612, follow these steps:
Step 1
Inspect the new drive for any signs of damage.
Step 2
Review the information in the
, and the
Step 3
Make sure that the chassis cover is in place and fully closed.
Step 4
Open the drive tray handle.
Step 5
Gently push the drive assembly into the bay until the drive stops. (See
Note
If you are replacing disk00 in a WAE-612, you must install it in the left
drive bay.
drive bay.