Cisco Systems 57712 Manual De Usuario
Complete a Command
You can use the Tab key in any mode to complete a command. Partially typing a command name and pressing
Tab causes the command to be displayed in full or to the point where another keyword must be chosen or an
argument value must be entered.
Tab causes the command to be displayed in full or to the point where another keyword must be chosen or an
argument value must be entered.
Command History
The CLI stores all commands used in the current session. You can step through the previously used commands
by using the Up Arrow or Down Arrow keys. The Up Arrow key steps to the previous command in the history,
and the Down Arrow key steps to the next command in the history. If you get to the end of the history, pressing
the Down Arrow key does nothing.
by using the Up Arrow or Down Arrow keys. The Up Arrow key steps to the previous command in the history,
and the Down Arrow key steps to the next command in the history. If you get to the end of the history, pressing
the Down Arrow key does nothing.
All commands in the history can be entered again by simply stepping through the history to recall the desired
command and pressing Enter. The command is entered as if you had manually typed it. You can also recall
a command and change it before you press Enter.
command and pressing Enter. The command is entered as if you had manually typed it. You can also recall
a command and change it before you press Enter.
Committing, Discarding, and Viewing Pending Commands
When you enter a configuration command in the CLI, the command is not applied until you enter the commit
command. Until committed, a configuration command is pending and can be discarded by entering a discard
command. When any command is pending, an asterisk (*) appears before the command prompt. The asterisk
disappears when you enter the commit command, as shown in this example:
command. Until committed, a configuration command is pending and can be discarded by entering a discard
command. When any command is pending, an asterisk (*) appears before the command prompt. The asterisk
disappears when you enter the commit command, as shown in this example:
Server#
scope chassis
Server /chassis #
set locator-led off
Server /chassis *#
commit
Server /chassis #
You can accumulate pending changes in multiple command modes and apply them together with a single
commit command. You can view the pending commands by entering the show configuration pending
command in any command mode.
commit command. You can view the pending commands by entering the show configuration pending
command in any command mode.
Committing multiple commands together is not an atomic operation. If any command fails, the successful
commands are applied despite the failure. Failed commands are reported in an error message.
commands are applied despite the failure. Failed commands are reported in an error message.
Note
Command Output Formats
Most CLI show commands accept an optional detail keyword that causes the output information to be displayed
as a list rather than a table. You can configure either of two presentation formats for displaying the output
information when the detail keyword is used. The format choices are as follows:
as a list rather than a table. You can configure either of two presentation formats for displaying the output
information when the detail keyword is used. The format choices are as follows:
• Default—For easy viewing, the command output is presented in a compact list.
This example shows command output in the default format:
Server /chassis #
set cli output default
Server /chassis #
show hdd detail
Name HDD_01_STATUS:
Status : present
Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5
8
OL-28893-01
Overview
Complete a Command