Cisco Systems 57712 Manual De Usuario

Purpose

Command or Action

Commits the transaction to the system
configuration.

Server /cimc/network # commit

Step 4

This example configures the common properties:

Server#

scope cimc

Server /cimc #

scope network

Server /cimc/network #

set hostname Server

Server /cimc/network *#

commit

Server /cimc/network #

Configuring IPv4

Before You Begin

You must log in as a user with admin privileges to configure IPv4 network settings.

Procedure

Purpose

Command or Action

Enters the CIMC command mode.

Server# scope cimc

Step 1

Enters the CIMC network command mode.

Server /cimc # scope network

Step 2

Selects whether the CIMC uses DHCP.

If DHCP is enabled, we recommend that
the DHCP server be configured to reserve
a single IP address for the CIMC. If the
CIMC is reachable through multiple ports
on the server, the single IP address must
be reserved for the full range of MAC
addresses of those ports.

Note

Server /cimc/network # set dhcp-enabled
{yes | no}

Step 3

Specifies the IP address for the CIMC.

Server /cimc/network # set v4-addr
ipv4-address

Step 4

Specifies the subnet mask for the IP address.

Server /cimc/network # set v4-netmask
ipv4-netmask

Step 5

Specifies the gateway for the IP address.

Server /cimc/network # set v4-gateway
gateway-ipv4-address

Step 6

Selects whether the CIMC retrieves the DNS server
addresses from DHCP.

Server /cimc/network # set dns-use-dhcp
{yes | no}

Step 7

Specifies the IP address of the primary DNS server.

Server /cimc/network # set
preferred-dns-server dns1-ipv4-address

Step 8

Cisco UCS C-Series Servers Integrated Management Controller CLI Configuration Guide, Release 1.5

OL-28893-01

Configuring Network-Related Settings

Configuring IPv4