Cisco Systems 612 Manual De Usuario

This section provides general information about the system board, riser card, 
adapters, and PCI-X slot configuration specifications. Use these instructions to 
install any full-height three-quarter-length PCI-X adapter card.

The MPEG decoder adapter is supported in ACNS software only. The inline 
network adapter is supported in WAAS 4.0.7 and later software only.

Before you install adapters, review the following information:

The adapter slots are on the riser card assembly. You must first remove the 
riser card assembly to access the adapter slots. (See 

The device has two Peripheral Component Interconnect-Extended (PCI-X) 
adapter slots: 

PCI-X slot 1 is for one full-height three-quarter-length adapter.

PCI-X slot 2 is for one low-profile half-length adapter; however, it is not 
used in this device.

You must install supported adapters in PCI-X slot 1. (This slot is labeled 
“Slot 1” on the back of the device.)

Documentation is included with the adapter. Follow the instructions in the 
adapter documentation in addition to the instructions in this chapter.

When you handle static-sensitive devices, take precautions to avoid damage from 
static electricity. For details on handling these devices, see the 

.

The illustrations in this document might differ slightly from your hardware.

To install an adapter, follow these steps:

Review the safety information in the 

.

Power down the device and peripheral devices.