Cisco Systems 612 Manual De Usuario

All hard disk drives being used in the WAE should have the same throughput 
speed rating. Mixing hard disk drives with different speed ratings will cause 
all hard disk drives to operate at the lower throughput speed.

To maintain proper system cooling, do not operate the device for more than 10 
minutes without either a hard disk drive or a filler panel installed in each bay.

The WAE-512 supports simple-swap SATA hard disk drives. Simple-swap hard 
disk drives are not hot-swappable. Disconnect all power from the server before 
removing or installing a simple-swap hard disk drive.

The WAE-612 hardware supports hot-swappable SATA hard disk drives; however, 
you must be running WAAS 4.0.13 or a later version to obtain the software 
support for hot-swapping. If you are running a WAAS version prior to 4.0.13, we 
recommend that you power down your WAE-612 when swapping or installing 
new hard disk drives.

To install an SATA hard disk drive in a bay, follow these steps:

Inspect the new drive for any signs of damage.

Review the information in the 

, and the 

Make sure that the chassis cover is in place and fully closed.

Power down the device and peripheral devices, and disconnect the power cord and 
all external cables.

If the drive bay contains a filler panel, remove it.

To install the hard disk drive, pull the loops of the drive tray toward each other 
and slide the drive into the bay until the drive connects to the backplane.

Insert the filler panel into the bay to cover the drive. (See