B&B Electronics UNO-2170 Manual De Usuario
You can select if you wish to combine the chassis grounding point with
the system grounding by using an onboard jumper selection. (JP7)
the system grounding by using an onboard jumper selection. (JP7)
Open - Separates system power ground and chassis
ground. (default)
ground. (default)
Closed - Connects system power ground and chassis
ground.
ground.
3.3 Connecting Power
Connect the UNO-2170 to a 9~36 VDC power source. The power source
can either be from a power adapter or an in-house power source.
can either be from a power adapter or an in-house power source.
3.4 Installing a Hard Disk
The procedure for installing a hard disk into the UNO-2170 is below.
Please follow these steps carefully.
Please follow these steps carefully.
1. Remove the power cord.
2. Unscrew four screws from the rear panel of the UNO-2170.
3. Remove the rear panel.
4. Connect the IDE flat cable to Primary (recommended; CN8) or
secondary IDE connector (CN9), then connect the other side of the
connector to the hard disk.
connector to the hard disk.
5. Screw back the rear panel with the four screws.
3.5 BIOS Setup and System Assignments
UNO-2170 adopts Advantech SOM-4481 or SOM-4486 CPU module.
Further information about the SOM-4481/4486 CPU module, can be
found in SOM-4481/4486 users manual. You can find this manual on the
UNO-2170s driver and utility CD-ROM.
Further information about the SOM-4481/4486 CPU module, can be
found in SOM-4481/4486 users manual. You can find this manual on the
UNO-2170s driver and utility CD-ROM.
Please note that you can try to “LOAD BIOS DEFAULTS＂ from the
BIOS Setup manual if the UNO-2170 does not work properly.
BIOS Setup manual if the UNO-2170 does not work properly.
19 Chapter 3