Casio YW-2L Manual De Usuario

Subnet Mask

Configuration of this setting is required when “Off” is selected for “DHCP”. 
Enter a subnet mask value, which specifies the range of the IP address of 
the subnet to which the Data Projector/computer belongs. The subnet mask 
consists of four values in the range of 0 to 255, separated by periods (such 
as 255.255.255.0).

Default 
Gateway

Configuration of this setting is required when “Off” is selected for “DHCP”. 
When “Access Point” is selected for “Access Mode”, specify the same value 
as the wireless LAN access point.

Channel

Configuration of this setting is required when “Ad Hoc” is selected for 
“Access Mode”. When there is a large number of devices performing wireless 
LAN communication using frequencies in the same frequency band (2.4 GHz) 
used by the Data Projector, you can improve communication performance by 
assigning different channels to each wireless LAN network. Normally you 
should leave this item set to “Auto” (initial default setting).

Auto*:

Automatically assigns a communication channel for wireless LAN 
communication. If “Auto” is selected on the Data Projector, also select 
“Auto” for the computer as well.

Specify a channel that should be used for wireless LAN communication. 
The same channel must be set on the Data Projector and the computer 
that will be communicating with each other over the wireless LAN 
connection.