Cabletron Systems 9E106-06 Manual De Usuario

 

2-9

Installing the 9E106-06 Module

 

See the 

 

 at the end of this table.

 

This module stores user entered passwords in NVRAM 
(Nonvolatile Random Access Memory). To clear these 
passwords, toggle this switch and then reset the module’s 
processor. Once the module resets, factory default passwords 
are placed in NVRAM. You can use these default passwords 
or, if desired, enter new passwords. To enter new passwords, 
refer to the Module Local Management User’s Guide.

 

This module stores user entered parameters such as IP 
addresses, subnet masks, default gateway, default interface, 
SNMP traps, bridge configurations and module specific 
configurations in NVRAM. To clear these parameters toggle 
this switch and then reset the module’s processor. Once the 
module resets, factory default parameters are placed in 
NVRAM. You can use the default parameters or, if desired, 
enter new parameters. To enter new parameters, refer to the 
Module Local Management User’s Guide.

 

This module uses BOOTP (Boot Strap Protocol) to download 
new versions of the image file into Flash Memory. This 
procedure forces image files to be downloaded from the PC 
or Workstation, configured to act as the BOOTP server, 
connected to the EPIM port in the Environmental Module.

 

For Factory Use Only

 

For Factory Use Only

 

For Factory Use Only

 

For Factory Use Only

 

For Factory Use Only