Cabletron Systems 9H531-17 Manual De Usuario

 

Installing the SmartSwitch 9000 Module

2-6

 

To install the SmartSwitch 9000 module, follow the steps below:

1. Remove the blank panel covering the two slots in which the module is being 

installed. All other slots must be covered, if other modules are not being 
installed, to ensure proper airflow and cooling.

2. Attach one end of the ESD wrist strap packaged with the SmartSwitch 9000 

chassis to your wrist. Plug the other end into the ESD Wrist Strap Grounding 
receptacle in the lower right corner of the SmartSwitch 9000 chassis shown in 
Figure 2-2. 

3. Grasp the module and slide it into the slots. Make sure that the module’s 

circuit card is between the card guides, as shown in Figure 2-2. Check both the 
upper and lower tracks of the card. Take care that the module slides in straight 
and engages the backplane connectors properly. 

4. Lock down the top and bottom plastic tabs, as shown in Figure 2-2.