Cabletron Systems TM 9C300-1 Manual De Usuario

3-15

Interactive Mode

Select <PWR> from the System Screen, as shown in Figure 3-15, to access 
information about the chassis power supply configuration. 

Line 1 of the Power Screen, as shown in Figure 3-16, displays the number of 
power supplies currently configured and the availability of power redundancy. 

Lines 2 and 3 display the power supply status as either ON, OFF DUE TO 
MANAGEMENT, or FAULT.

Line 4 is used to access information about a specific power supply module by 
selecting a power supply number. 

Figure 3-16. The Power Screen

Select <EXIT> to return to the System Screen.

Select a power supply number from line 4 of the Power Screen, as shown in 
Figure 3-16, to learn about a specific power supply in the MMAC-Plus chassis. 
There is an LCD screen available for each installed power supply, as shown in 
Figure 3-17. 

Line 1 identifies the power supply selected and its serial number. 

Line 2 identifies the power supply’s hardware revision, firmware revision of the 
diagnostic controller and power loading factor as a percentage of its capacity. 

Line 3 provides the input and output voltages of the power supply.

Figure 3-17. The Power Supply Specific Screen

Select <EXIT> to return to the Power Screen.

STATUS 1 ON 2 ON

<1>

SUPPLIES INSTALLED 2 PWR REDUNDANCY

<EXIT>

<2>

HW REV xxx FW REV x.xx.xx LOAD xxx%

<EXIT>

PWR SUPPLY 1 SN xxxxxxxxxxxx

PWR IN 110V PWR OUT 57.1V 5.1V 3.3V