Cabletron Systems HSIM-W6 Manual De Usuario
Chapter 7: General Configuration Using Local Management
HSIM-W6 User’s Guide
165
WAN Physical Configuration Screen Fields
The following list describes the WAN Physical Configuration screen fields.
WPIM # —
Displays configuration information for the WPIMs that are installed.
Type —
Displays the WPIM type.
BRIM # —
Displays the BRIM slot in which the WPIM resides.
Mode —
Displays the WPIM mode.
Active —
Displays the status of the WPIM.
Ifaces —
Displays the interfaces available to each WPIM.
WPIM-HDSL Configuration Fields
HDSL Tx Clock Source —
Displays the HDSL Transmit Clock Source. The selections for this
field toggle between Loop-Timing (Extracted Line Data) and Local-Timing (Internal Clock). The
default setting for this field is Loop-Timing.
default setting for this field is Loop-Timing.
HDSL Timeslot Configuration —
Displays the timeslot configuration for the WPIM. The
selections for this field toggle between Full and Fractional. The default setting for this field is Full.
Full uses all 24 timeslots and Fractional uses the first 12 timeslots.
Full uses all 24 timeslots and Fractional uses the first 12 timeslots.
NOTE
shows the WAN Physical
Configuration screen for the WPIM-HDSL and the WPIM-T1. To select the WPIM you
wish to configure, use the arrow keys to highlight the [WPIM #] field at the bottom of the
screen. Use the SPACEBAR to select the appropriate WPIM, then press ENTER.
wish to configure, use the arrow keys to highlight the [WPIM #] field at the bottom of the
screen. Use the SPACEBAR to select the appropriate WPIM, then press ENTER.
NOTE
The Loop-Timing selection in this Local Management screen corresponds to the Slave
selection in the QuickSET HDSL WAN Configuration window; the Local-Timing
selection corresponds to the Master selection.
selection in the QuickSET HDSL WAN Configuration window; the Local-Timing
selection corresponds to the Master selection.